Vision Fitness T8100 Informations techniques télécharger pdf (Page 66)

Communications processor console utility: cpcon TX Utilities Manual

TDM pattern test commands

Use the following [t81] commands to verify TDM (H.100/H.110 or T1/E1

connectivity) between two TX boards:

Command Description

check

Checks received patterns across a stream range using the following syntax:

check bus min stream [max stream [ts delta [pattern]]]

reflect

Reflects timeslots across a stream range using the following syntax:

reflect bus min stream [max stream [ts delta]]

spread

Spreads patterns across a stream range using the following syntax:

spread bus min stream [max stream [ts delta [pattern]]]

vreflect

Verifies CAM definitions (reflecting timeslots) using the following syntax:

vreflect bus min stream [max stream [ts delta]]

vspread

Verifies CAM definitions (spreading patterns) using the following syntax:

vspread bus min stream [max stream [ts delta [pattern]]]

The following parameters apply to each command:

Parameter Description

bus Valid values:

H = H.100/H.110 bus (resource direction).

N = H.100/H.110 bus (network direction).

L = LOCAL bus.

min stream Minimum stream number (paired with min+1 for H.100/H.110 bus).

max stream Maximum stream number (paired with max-1 for H.100/H.110 bus). Default: min

stream+1.

ts delta Delta used to reach next timeslot. Default: 1.

Note: Each time the stream is incremented (by 2), the next timeslot is reset to 0.

pattern Constant pattern to send or expect. If not specified, then a range of patterns is

used.

Follow this procedure to use the pattern test commands:

Step Action

1 Connect two TX boards with either an H.100/H.110 cable or a T1/E1 crossover cable.

2 Download a TDM configuration file to each board specifying TDM clocking configuration (and T1

or E1 configuration if testing T1/E1).

3 On one TX board, use the reflect command to define a set of connections that reflect patterns

received over H.100/H.110 (or T1/E1) and transmitted over H.100/H.110 (or T1/E1).

4 On the other board, use the spread command to spread a set of outbound patterns over the

interface being tested.

5 Use the check command on the same TX board that the spread command was entered on to

verify that the proper reflected patterns are received.

6 Use the vreflect and vspread commands to verify that all connections made using the

corresponding command (reflect or spread) are actually in the TDM switching control database.

66 Dialogic Corporation

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 74 75

Commentaires sur ces manuels

Pas de commentaire

Vision Fitness T8100 Informations techniques Page 66

Commentaires sur ces manuels

Produits connexes et manuels pour Tapis de course Vision Fitness T8100