Vision Fitness T8100 Informations techniques télécharger pdf (Page 41)

TX Utilities Manual Communications processor console utility: cpcon

[debug] System debugger commands

Use [debug] commands to debug a TX board-based task. To use [debug], download

the debug task (debug.elf) to the board. By default, debug.elf is commented out in

the ss7load script. Uncomment the line and run the modified ss7load to boot the

board and download the task.

The following table lists the [debug] commands:

[debug] commands Description

asm Displays area indicated as PowerPC ASM instructions.

break Sets a breakpoint at the indicated symbol location or address.

breaks Lists all of the currently defined breakpoints for the selected task.

clear Removes a breakpoint at the indicated symbol location or address.

clearall Removes all breakpoints for a particular task.

clrmon Clears the selected area for monitoring.

dstack Dumps the stack of the currently selected task as raw hexadecimal data.

info Displays information about the debug session.

kdstack Dumps the kernel stack as raw hexadecimal data.

kregs Displays the kernel registers.

kstack Dumps the kernel call stack.

ksym Displays kernel symbol information.

mon Monitors the indicated area for changes.

regs Displays registers for the currently selected task or live registers.

regset Sets the given register to the specified value.

run Runs the currently selected task.

stack Dumps the selected task call stack.

s Steps through the currently selected task (default is step over).

si Steps into every instruction.

stop Stops the currently selected task.

sym Displays symbol information (name, address).

symset Sets the value of memory at the symbol location indicated.

symshow Displays the value of memory at the symbol location indicated.

task Sets the current debug task.

Dialogic Corporation 41

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 74 75

Pas de commentaire

Vision Fitness T8100 Informations techniques Page 41