Vision Fitness T8100 Informations techniques télécharger pdf (Page 47)

TX Utilities Manual Communications processor console utility: cpcon

udp

Shows a list of UDP ports or details for a specific port (optionally zeroing statistics

immediately after they have been displayed) using the following syntax:

udp [<UDP port>|* [ZERO]]

proto

Shows a list of IP protocols or details for a specific protocol (optionally zeroing

statistics immediately after they have been displayed) using the following syntax:

proto [<protocol number>|* [ZERO]]

ifopt

Specifies an IP interface configuration option using the following syntax:

ifopt [!]<optName>[ = <optValue>]

where bit options are specified as:

Value Description

optName optName indicates that the option is enabled.

!optName indicates that the option is disabled.

optValue Value options are specified as:

optName = optValue

The following table describes the options that can be specified using the ifopt

command:

Option Type Description

PINGBLOCK BIT Indicates if automatic responses to PING messages are blocked.

MTU VALUE Maximum transmission unit (in bytes).

FRAGDROP SECS Partial fragment drop timeout.

HOPLIMIT VALUE Not applicable in this release.

ICMPRATE VALUE Not applicable in this release.

IPV6 BIT Not applicable in this release.

IPSEC BIT Not applicable in this release.

NDATTEMPTS VALUE Specifies the neighbor discovery attempt (NDA) limit for the specified

Ethernet interface.

NDRETRAN SECS Neighbor discovery retransmission timeout.

NDREACH SECS Not applicable in this release.

ARPRETRY MSECS Amount of time to wait after issuing an ARP request before re-transmitting

the same ARP request.

ARPMAX VALUE Maximum number of times to retry an ARP request before terminating retry

attempts, considering the remote entity is unreachable.

ARPREACH MSECS Maximum amount of time without receiving any message from the remote IP

address before probing to verify connectivity.

ARPUNUSED MSECS Amount of time that an unused ARP entry remains in the ARP table. An ARP

entry is used each time an outbound IP packet is sent to the remote entity

for the given ARP entry.

Dialogic Corporation 47

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 74 75

Pas de commentaire

Vision Fitness T8100 Informations techniques Page 47