Vision-fitness X6850HRT Manuel d'utilisateur télécharger pdf (Page 30)

GENERAL

USING FACILITY ENGINEERING MODE SETTINGS

Engineering mode is used to customize your Incline Elliptical Trainer for

your facilities needs, or to view useful information about your Incline

Elliptical Trainer. These features are only accessible to your staff when they

press the keys in a specific sequence.

USING ENGINEERING MODE

• To enter press and hold the RESISTANCE UP and RESISTANCE

DOWN arrow keys simultaneously for four seconds or until you see

the message.

• When in engineering mode you can scroll through the optional

settings by using the UP and DOWN arrow keys. Press the ENTER

key to select the setting you wish to view or modify.

• Use the UP and DOWN arrow keys to modify the settings.

• Press the ENTER key to save your setting.

• Press and hold the PAUSE key for four seconds to exit engineering mode.

The following settings will be available in the engineering mode:

MAXIMUM TIME –

The manager has the ability to set the maximum time

the workouts can be set for. This feature is necessary for busy facilities

that may want to limit the amount of time their users are on the Incline

Elliptical Trainer. The default is 99 minutes.

USER DEFAULT TIME –

This mode allows you to set a specific default time

for setup mode. This default time will also be used when the exerciser

presses START for a quick start program.

USER DEFAULT AGE –

This mode allows you to set a specific default age

for setup mode. This is particularly useful when the Incline Elliptical

Trainer is placed at a facility where the user’s age range is very

specific, such as a school. This default age will also be used when

the exerciser presses START for a quick start program.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Pas de commentaire

Vision-fitness X6850HRT Manuel d'utilisateur Page 30