AssemblyGuideST250LEG PRESS
103STEP• Lay the seatback (2a) face down.Mate the seatback support (2b) to 2a.Make sure the holes of 2b are pointingup towards the top of the seatback
114STEP• Insert the lever arm (3a) into the triangular structure at the front of 1b.When the holes are lined up, insert the90mm shaft along with a fla
125STEP• If you already have the base unitassembled with cable #2 and areadding the leg press to it, follow thisinstruction, otherwise proceed to Ste
136STEP• Attach the pulley structure (U) to thebottom rear floor support of the baseunit with three bolts (M6x1Px15L), threeflat (6.4x14x1T), and thre
147STEP• Begin routing cable #6 with the endopposite the steel ball end. Feed thecable over pulley R, under S, aroundT, and under U. Unscrew the nut f
158STEP• Attach the decals according to the diagram below.DECALSPINCH POINTSAFETY DECALPLACEMENT
500 South CP Avenue • P.O. Box 280 • Lake Mills. WI 53551toll free 800.335.4348 • phone 920.648.4090 • fax 920.648.3373www.visionfitness.com
2To avoid possible damage to this Leg Press, please follow these assembly steps in the correct order. Before proceeding, find yournew Leg Press’ seria
35STEP3STEP2STEP4STEP6STEP7STEP8STEP1STEP
419mm Wrench6mm L-Shaped Wrench (2)TOOLS & PARTS INCLUDEDPARTS BOXColor-coded Hardware BagsOwner’s GuideAssembly GuideWarranty Card10mm/17mm Wrenc
5ORANGE BAGBLUE BAGHARDWARE INCLUDEDM10 x 1.5P NutQuantity: 1210.5 x 18 x 2T Flat WasherQuantity: 16M10 x 1.5P x 60L Carriage BoltQuantity: 2SW10.2 x
6PINK BAGGREEN BAGHARDWARE INCLUDED10.5 x 18 x 2T Flat WasherQuantity: 2M10 x 1.5P NutQuantity: 2M6 x 1P x 15L BoltQuantity: 390mm ShaftQuantity: 110.
7BLACK BAG15x33LShoulder BoltQuantity: 1U BracketQuantity: 1M12 Slotted BoltQuantity: 1M10 x 1.5P NutQuantity: 110.5 x 18 x 2T Flat WasherQuantity: 1S
81STEP• If you aren’t adding any weightplates to the stack, skip this step andproceed to Step 2. • Your unit is equipped to handle 21-ten pound plates
91b1a1d1c1e1e2STEP• Attach the connecting brace (1a) tothe empty holes on the left floor support of the base unit (ST200).Connect with two carriage bo
Commentaires sur ces manuels