Vision Fitness X20 Spécifications télécharger pdf (Page 51)

7.14 DRIVE AXLE ASSEMBLY REPLACEMENT

1) Remove the side covers as outlined in Section 7.12.

2) Loosen the 2 large nuts holding the ECB tightly to the frame (Figure A).

3) Loosen the 2 eye bolt nuts putting tension on the belt (Figure B)

4) Once the ECB is no longer held tightly to the frame, push up on the ECB. This will release the tension on the belt allowing you to remove it

from the drive axle pulley (Figure C).

5) Remove the snap ring holding the drive axle to the frame (Figure D).

6) Use a hammer to knock the drive axle out of the frame towards the left side of the unit (Figure E). NOTE: The drive axle and bearings will

be wrecked during the removal process.

7) Reverse Steps 1-6 to install a new drive axle assembly.

CHAPTER 7: PART REPLACEMENT GUIDE

FIGURE D

FIGURE E

FIGURE CFIGURE BFIGURE A

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Pas de commentaire

Vision Fitness X20 Spécifications Page 51